Project

General

Profile

MOBIKE » History » Version 3

« Previous - Version 3/5 (diff) - Next » - Current version
Martin Willi, 01.04.2008 11:13


= MOBIKE =

The MOBIKE IKEv2 extension allows an initiator to change its network attachement point (e.g. roam to an other interface/address).

strongSwan implements MOBIKE by watching interfaces, addresses and routes. If the configuration changes, route lookups are done to find a better path than the current one and changes this path using a MOBIKE update (''UPDATE_SA_ADDRESS'').

strongSwan is running the MOBIKE protocol per default as soon as you specify ''keyexchange=ikev2''. MOBIKE can be disabled on a per-connection basis, though, by adding the parameter ''mobike=no'' to the corresponding connection definition in ''ipsec.conf''. Please be aware that with MOBIKE enabled, strongSwan will switch to UDP port 4500 starting with the IKE_AUTH request which includes a ''MOBIKE_SUPPORTED'' notification even if no NAT has been detected. Thus make sure to open the NAT-traversal port UDP/4500 on any firewalls en route.

strongSwan's MOBIKE implementation is currently usable, but needs further testing to work more reliable.