Project

General

Profile

Issue #2867

Starting strongSwan 5.7.1

Added by Louis garcia 9 months ago. Updated 7 months ago.

Status:
Closed
Priority:
Normal
Category:
starter
Affected version:
5.7.1
Resolution:
No feedback

Description

Hello everybody !
I am trying to take the Mobile IPv6 HOWTO as an example of configuration but when I run the "ipsec start" command I have just one line as an output (Starting strongSwan 5.7.1 IPsec [starter] ...) then it doesn't show anything else how is shown in the Mobile IPv6 HOWTO (logs informing about the access to some directories to take some files like loading ca certificates). If I can't see these logs I can't know if it works well or not. I thought maybe the log info it isn't shown in the 5.7.1 version but I'm not sure because I have used all the information that I found in the tutorials in this page but I don't know what is the reason.

History

#1 Updated by Tobias Brunner 9 months ago

  • Status changed from New to Feedback
  • Priority changed from Urgent to Normal

Please start by reading Introduction to strongSwan.

#2 Updated by Tobias Brunner 7 months ago

  • Status changed from Feedback to Closed
  • Assignee set to Tobias Brunner
  • Resolution set to No feedback

Also available in: Atom PDF